System Options For Single Line Telephones - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 20-03 : System Options for Single Line Telephones to set up various options for single
line telephones.
Input Data
Item
No.
01 SLT Call Waiting Answer Mode
For a busy single line (500/2500 type)
telephone, set the mode used to answer a
camped-on trunk call.
02
Ignore Received DP Dial on DTMF SLT Port
Define whether the system should receive dial
pulse and DTMF signals (0) or ignore dial
pulse and only accept DTMF signals (1).
03
SLT DTMF Dial to Trunk Lines
Type 0: The system keeps the digits

dialed by the single line telephone on a
trunk in a buffer. After all the digits are
received, the system sends all the
digits to the trunk. If the time space
between digits is longer than the time
in Item 4, the system considers all
digits received.
Type 1: The system passes the

received digits from the single line
telephone to the trunk immediately. If
the single line telephone has a Last
Number Dial key without a pause, this
key may not be able to use the Last
Number Dial key with the Type 1
setting.
When using a third-party external paging
device, set this option to 1. In addition, set
Program 20-03-04 to 1. These programs must
be set for Wireless – DECT users to be able
to break dial tone on an analog trunk that is
used for paging.
2-252
Program 20 : System Option Setup

20-03 : System Options for Single Line Telephones

Item Input Data Default
0 = Hookflash
(Hooking)
1 = Hookflash +
Service Code
794
0 = Do Not Ignore
(No)
1 = Ignore (Yes)
0 = Receive all
dialed data,
before sending
(All)
1 = Direct through
out (Direct)
Related
Program
0 11-12-47
0 15-03-01
0 20-03-04
Program 20 : System Option Setup
Issue 4.0