Incoming Call Trunk Setup - NEC univerge SV9100 Programming Manual

Issue 4.0
Level:
IN
Description
Use Program 22-02 : Incoming Call Trunk Setup to assign the incoming trunk type for each trunk.
There is one item for each Night Service Mode.
Input Data
Trunk Port Number
Day/
Item
Night
No.
Mode
01 1~8
Conditions
When connecting to T1 trunks, after changing Program 22-02-01 to match the Telco connected T1

service type, the T1 cable or the T1 blade must be unplugged and then reconnected for the T1 blade
to sync.
When the trunk type is set to 3 (DID), the DID Transfer to Destination in 22-11-04 for each DID feature

is not supported. This feature is supported only for DID trunks when assigned as VRS.
When the trunk type is set to 3 (DID), the DID Intercept Destination feature for each DID is not

supported. This feature is supported only for DID trunks assigned as VRS.
SV9100 Programming Manual
Program 22 : Incoming Call Setup
Incoming Type Default
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching

22-02 : Incoming Call Trunk Setup

001~400
Description
0 Set the feature type for the
trunk you are programming.
Related
Program
14-04
2-361