Flexible Setup For Room Status - NEC univerge SV9100 Programming Manual

Issue 4.0
Level:
IN
Description
Use Program 42-07 : Flexible Setup for Room Status to enable dial room status codes. Note the code
definitions only apply to the system itself. When sending room status messages to the PMS Application,
the status codes are always sent as defined in the PMS Developer Guide.
For example, if in PRG 42-09-01 status code 1 is set to Inspection Required. The PMS Developer Guide
defines "Inspection Required" as status message number 4. If in the SV9100 room status 1 is assigned
to a room the PVA PMS interface will send status message number 4 to the PMS Application. If nothing
is assigned in
PRG 42-09-01 the default room status codes are sent as defined in the PMS Developer Guide.
Input Data
Item
No.
01

Flexible Setup for Room Status

Conditions
None
Feature Cross Reference

Hotel/Motel
SV9100 Programming Manual
42-09 : Flexible Setup for Room Status
Item
1 = Room Clean (Occupied)
2 = Maid Required
3 = Maid in Room
4 = Inspection Required
5 = Maintenance Request
6 = Out of order
7 = Reserve 1
8 = Reserve 2
9 = Reserve 3
0 = Room Clean (Vacant)
= Reserve 5

# = Reserve 6
Program 42 : Hotel Setup
Input Data Default
0
2-547