NEC univerge SV9100 Programming Manual page 499

Issue 4.0
Table 2-12 Keys for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad
digit . . .
#
Conf
Hold
Input Data
Internal Paging Group Number
Item
No.
01
Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Default
Item 01 : Internal Paging Group Name
Extension
Paging Group
01
02
:
64
SV9100 Programming Manual
Key for Entering Names (Continued)
When you want to. . .
# = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing
mode, use the right arrow soft key instead to accept and/or add a
space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Item
Name
Group 1
Group 2
:
Group 64
# again = Space. (In system programming
01~64
Input Data
Up to 12 Characters
Default
Refer to default table.
2-459