System Timers For Vrs/Disa - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 25-07 : System Timers for VRS/DISA to set the value for the system timers which affect
DID and DISA. Refer to the following chart for a description of each option, its range and default setting.
Input Data
Item
No.
01 VRS/DISA Dial Tone Time
After answering a DISA trunk, the system waits this time
for the caller to dial the first digit of the DISA password. If
the caller fails to dial during this time, the system drops
the call.
02
VRS/DISA No Answer Time
A VRS/DISA caller can ring an extension for this time
before the system sets the call as a Ring No Answer.
After this time expires, the call follows the programmed
Ring No Answer routing (set in Program 25-03 and
25-04).
03 Disconnect after VRS/DISA retransfer to IRG
From DISA trunk, when the call may go to Incoming Ring
Group of PRG25-03/25-04. This setting determines the
time the call is ringing in the IRG.
04
Calling Time to Automatic Answering Telephone Set
Set the answering waiting time of the automatic
answering extension when an incoming DID trunk call is
received.
05
Duration Time for Guidance Message by Automatic
Answering Telephone Set
Set the announcement time of the automatic answering
extension after which an incoming DID trunk caller is
disconnected.
06 Duration Time for Guidance Message by ACI
Set the announcement time by the ACI after which an
incoming DID trunk caller is disconnected.
2-410
Program 25 : VRS/DISA Setup

25-07 : System Timers for VRS/DISA

Item
Input Related
Default
Data Program
0~64800 10
(sec)
0~64800 0
(sec)
0~64800 60
(sec)
0~64800 10
(sec)
0~64800 10
(sec)
0~64800 10
(sec)
Program 25 : VRS/DISA Setup
Issue 4.0
25-04
25-04