Did Basic Data Setup - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 22-09 : DID Basic Data Setup to define the basic setting of Dial-In incoming calls for
each trunk group.
Input Data
Trunk Group Number
Item
No.
01
Expected Number of Digits
Enter the number of digits the table
expects to receive from the telco. Use this
program to make the system compatible
with 3- and 4-digit DID service.
If ISDN trunks, we analyze the last digits
that are set here. If it is T-1 or analog DID,
it analyzes the first digits that are assigned
here.
02 Received Vacant Number Operation
Enable/Disable Vacant Number Intercept.
03
Sub-Addressing Mode
04 DID Receiving Mode for ISDN
05 Local Code Digits
(Only Overlap Receiving Mode)
06
Local Code
(Only Overlap Receiving Mode)
07 Pilot Code
(Only Overlap Receiving Mode)
2-370
Program 22 : Incoming Call Setup
Item
1~8
0 = Disconnect (Cut)
1 = Transfer (Refer to
0 = Extension # Specify
1 = DID Conversion Table
0 = Enbloc Receiving
1 = Overlap Receiving
0~15 (0 = No Local Code)
Dial (maximum 16 digits)
Dial (1 digit: 0~9)

22-09 : DID Basic Data Setup

001~100
Input Data
Program
22-12 : DID Intercept Ring
Group on page 2-378.)
(Intercom)
Issue 4.0
Default
4
0
0
0
0
No Setting
No Setting
Program 22 : Incoming Call Setup