Table of Contents
Advertisement
How to Program
2.1.6 Parameter Set-up
2
2
The adjustable frequency drive can be used for practically all
assignments, which is why the number of parameters is quite
large. The adjustable frequency drive offers a choice
between two programming modes - a Main Menu and a
Quick Menu mode.
The former provides access to all parameters. The latter takes
the user through a few parameters, making it possible to
start operating the adjustable frequency drive.
Regardless of the mode of programming, you can change a
parameter both in the main menu and quick menu modes.
2.1.7 Quick Menu Key Functions
Pressing [Quick Menus] The list indicates the different areas
contained in the Quick menu.
Select My Personal Menu to display the chosen personal
parameters. These parameters are selected in 0-25 My
Personal Menu. Up to 20 different parameters can be added
in this menu.
Select Quick set-up to go through a limited amount of
parameters to get the motor running almost optimally. The
default setting for the other parameters considers the
desired control functions and the configuration of signal
inputs/outputs (control terminals).
Parameters are selected by using the arrow keys. The
parameters in the following table are accessible.
2-6
FC 300 Programming Guide
Parameter
0-01 Language
1-20 Motor Power [kW]
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
5-12 Terminal 27 Digital Input
1-29 Automatic Motor
Adaptation (AMA)
3-02 Minimum Reference
3-03 Maximum Reference
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time
3-13 Reference Site
* If terminal 27 is set to "no function", no connection to +24
V on terminal 27 is necessary.
Select Changes made to get information about:
•
•
Select Loggings to get information about the display line
readouts. The information is shown as graphs.
Only display parameters selected in 0-20 Display Line 1.1
Small and 0-24 Display Line 3 Large can be viewed. It is
possible to store up to 120 samples in the memory for later
reference.
®
MG.33.MA.22 - VLT
is a registered Danfoss trademark
Setting
[kW]
[V]
[Hz]
[A]
[rpm]
[0] No function*
[1] Enable complete AMA
[rpm]
[rpm]
[sec]
[sec]
▲
the last 10 changes. Use the [
to scroll between the last 10 changed parameters.
the changes made since default setting.
▼
] [
] navigation keys
Advertisement
Table of Contents
