Using The Cli To Configure The Management, Ap-Manager, Virtual, And Service-Port Interfaces; Using The Cli To Configure The Management Interface; Using The Cli To Configure The Ap-Manager Interface - Cisco OL-8335-02 Configuration Manual

Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Using the CLI to Configure the Management, AP-Manager, Virtual, and
Service-Port Interfaces
This section provides instructions for displaying and configuring the management, AP-manager, virtual,
and service-port interfaces using the CLI.

Using the CLI to Configure the Management Interface

Follow these steps to display and configure the management interface parameters using the CLI.
Enter show interface detailed management to view the current management interface settings.
Step 1
Note
Step 2 Enter config wlan disable wlan-number to disable each WLAN that uses the management interface for
distribution system communication.
Enter these commands to define the management interface:
Step 3
•
•
•
•
•
Enter show interface detailed management to verify that your changes have been saved.
Step 4

Using the CLI to Configure the AP-Manager Interface

Follow these steps to display and configure the AP-manager interface parameters using the CLI.
Enter show interface summary to view the current interfaces.
Step 1
Note
Step 2 Enter show interface detailed ap-manager to view the current AP-manager interface settings.
3-12
The management interface uses the controller's factory-set distribution system MAC address.
config interface address management ip-addr ip-netmask gateway
config interface vlan management {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
that only tagged VLANs be used on the controller.
config interface port management physical-ds-port-number
config interface dhcp management ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl management access-control-list-name
To create ACLs, follow the instructions in
Note
If the system is operating in Layer 2 mode, the AP-manager interface is not listed.
Chapter 3 Configuring Ports and Interfaces
Chapter 5.
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02