Table of Contents
Advertisement
See Cisco Wireless LAN Controller Configuration Guide for more information.
Choosing a Physical Location
You can install the controller almost anywhere, but it is more secure and reliable if you install it in a
secure equipment room or wiring closet. For maximum reliability, mount the controller while following
these guidelines:
•
•
•
•
•
•
Installing the Controller
This section includes the following installation procedures:
•
•
•
•
Mounting the Controller
This section includes the following mounting procedures:
•
•
•
•
Mounting the Controller on a Desktop or Shelf
Before mounting the controller on a desktop or shelf, install the rubber feet located in accessory kit
shipped with the controller.
To install the rubber feet to the controller, follow these steps:
Locate the adhesive strip with the rubber feet in the mounting-kit envelope.
Step 1
Make sure you can reach the controller and all cables attached to it.
Make sure that water or excessive moisture cannot get into the controller.
Make sure that airflow through the controller is not obstructed. Leave at least 4 in. (10 cm) clear on
both sides and rear of the controller.
Verify that the ambient temperature remains between 32 to 104° F (0 to 40° C).
Make sure that the controller is within 328 ft. (100 m) of equipment connected to the 10/100/1000
Mb/s Ethernet ports.
Make sure that the power cord can reach a 100 to 240 VAC grounded electrical outlet.
Mounting the Controller, page 11
Connecting the Controller Console Port, page 18
Securing the Power Adapter Cable, page 19
Installing a Security Lock, page 20
Mounting the Controller on a Desktop or Shelf
Mounting the Controller on a Wall (Rack-Mount Brackets)
Mounting the Controller on a Wall (Mounting Screws)
Mounting the Controller in a Rack
Cisco 2500 Series Wireless Controller Getting Started Guide
Installing the Controller
11
Advertisement
Table of Contents
