Using The Gui To Configure Conditional Web Redirect; Using The Cli To Configure Conditional Web Redirect - Cisco SD2008T-NA Configuration Manual

Configuring WLANs

Using the GUI to Configure Conditional Web Redirect

Follow these steps to configure conditional web redirect using the controller GUI.
Step 1 Click WLANs to access the WLANs page.
Click the Edit link for the desired WLAN. The WLANs > Edit page appears (see
Step 2
Figure 6-17 WLANs > Edit Page
Step 3 Make sure that 802.1X or WPA1+WPA2 is selected for Layer 2 Security.
Check the Web Policy check box under Layer 3 Security.
Step 4
Choose Conditional Web Redirect to enable this feature. The default value is disabled (unchecked
Step 5
box).
Step 6 If the user is to be redirected to a site external to the controller, choose the ACL that was configured on
your RADIUS server from the Preauthentication ACL drop-down list.
Step 7 Click Apply to commit your changes.
Step 8 Click Save Configuration to save your changes.

Using the CLI to Configure Conditional Web Redirect

Follow these steps to configure conditional web redirect using the controller CLI.
To enable or disable conditional web redirect, enter this command:
Step 1
config wlan security cond-web-redir {enable | disable} wlan_id
To save your settings, enter this command:
Step 2
save config
Cisco Wireless LAN Controller Configuration Guide
6-34
Chapter 6 Configuring WLANsWireless Device Access
Figure 6-17).
OL-1926-06OL-9141-03