Hotswap Cli Example - Cisco CS-MARS-20-K9 - Security MARS 20 User Manual

Chapter 24 System Maintenance
From the CLI, enter raidstatus.
Step 10
The subunit with the slot number of the replaced hard drive should indicate that the RAID subunit is
rebuilding, though the physical port number indicates the drive is degraded. This process can last from
90 minutes and 2 hours depending on the amount of data.
Verify the system has completed rebuilding the new hard drive before you hotswap another hard drive.
Note
The RAID subsystem rebuilds only one disk at a time. If the hotswapped drive does not rebuild after a
couple of hours, rebuild the array with the RAID Controller utility, as explained in the section,
"Rebuilding an Array with the RAID
This ends the

Hotswap CLI Example

This section pertains only to the MARS 100, 100E, 200, GCM, and GC appliances.
The following CLI output example hotswaps a hard drive in drive slot 6 (port 2) of a MARS 200. Physical
port 2 remains degraded until RAID subunit 2 is rebuilt.
Example 24-2 Hotswap Procedure, CLI Output Example
[pnadmin]$ hotswap remove 6
removing port /c0/p2 ... Done.
Disk 6 can now be safely removed from the system.
pnadmin]$ hotswap add 6
rescanning controller /c0 for units and drives ...Done.
Rebuild started on unit /c0/u0
Disk 6 has been added to the system successfully.
[pnadmin]$ raidstatus
Controller: c0
-------------
Driver:
Model:
FW:
BIOS:
Monitor:
Serial #: L14104A5090383
PCB:
PCHIP:
ACHIP:
# of units: 1
Unit 0: RAID 10 931.54 GB ( 1953580032 blocks): REBUILDING (64%)
# of ports: 8
Port 0: WDC WD2500JB-19GVA0 WD-WCAL73129135 232.88 GB (488397168 blocks)
: OK(unit 0)
Port 1: WDC WD2500JB-19GVA0 WD-WCAL73291174 232.88 GB (488397168 blocks)
: OK(unit 0)
Port 2: WDC WD2500JB-19GVA0 WD-WCAL73157538 232.88 GB (488397168 blocks)
: OK(unit 0)
Port 3: WDC WD2500JB-98GVA0 WD-WMAL72243570 232.88 GB (488397168 blocks)
78-17020-01
Hotswap Procedure To Remove and Add a Hard
1.02.00.037
7506-8
FE7X 1.05.00.068
BE7X 1.08.00.048
ME7X 1.01.00.040
Rev4
1.30-66
3.20
Hardware Maintenance Tasks—MARS 100, 100E, 200, GCM, and GC
Utility."
Drive.
User Guide for Cisco Security MARS Local Controller
24-19