Using The Cli To Create A Lobby Ambassador Account; Creating Guest User Accounts As A Lobby Ambassador - Cisco SD2008T-NA Configuration Manual

Creating Guest User Accounts

Using the CLI to Create a Lobby Ambassador Account

Enter this command to create a lobby ambassador account using the controller CLI:
config mgmtuser add lobbyadmin_username lobbyadmin_pwd lobby-admin
Replacing lobby-admin with read-only creates an account with read-only privileges. Replacing
Note
lobby-admin with read-write creates an administrative account with both read and write privileges.

Creating Guest User Accounts as a Lobby Ambassador

A lobby ambassador would follow these steps to create guest user accounts.
A lobby ambassador cannot access the controller CLI interface and therefore can create guest user
Note
accounts only from the controller GUI.
Log into the controller as the lobby ambassador, using the username and password specified in the
Step 1
"Creating a Lobby Ambassador Account"
Guest Users List page appears (see
Figure 9-3
Step 2 Click New to create a guest user account. The Lobby Ambassador Guest Management > Guest Users
List > New page appears (see
Figure 9-4
Cisco Wireless LAN Controller Configuration Guide
9-4
Figure
Lobby Ambassador Guest Management > Guest Users List Page
Figure 9-4).
Lobby Ambassador Guest Management > Guest Users List > New Page
section above. The Lobby Ambassador Guest Management >
9-3).
Chapter 9 Managing User Accounts
OL-9141-03