Omron C200H-MC221 Operation Manual page 148

Interface Bits
Word Bit
n+11 Task 1 00
Status S
Flags Flags
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
n+12 00 to 15
128
Task Error Flag g
Not used
Automatic Mode Flag g
Manual Mode Flag g
Memory Run Flag y g
Memory Run Completed
Flag ag
Optional Input Standby p p y
M Code Reset Standby y
M Strobe
Cycle Start Received y
Not used
Not used
Teaching Address g
S Setting Completed i C l d
Teaching Completed g p
Teaching Error g
Teaching Address Over g
Task 2 M code 0000 to 0999 (4-digit BCD)
2 1
0 x10 x10 x10
The M code is output, which is valid when the M strobe is turned ON.
Description
1 A task error occurred.
0 Normal
1 The Unit is in automatic mode.
0 Mode other than the above.
1 The Unit is in manual mode.
0 Mode other than the above.
1 The MC program is being executed.
0 Mode other than the above.
1 MC program execution has been
completed. (G79 was executed.)
0 Mode other than the above.
1 Waiting for optional input.
0 Mode other than the above.
1 Waiting for M code reset.
0 Mode other than the above.
↑ An M code (0 to 999) is being output.
M code reset
↓
↑ The Cycle Start Signal was received.
↓ The Cycle Start Signal is OFF.
The teaching address has been set.
↑
↓ Teaching address set command is OFF.
↑ Teaching has been completed.
↓ Teaching command is OFF.
↑ A teaching error occurred.
OFF when the next teaching command is
↓
completed normally or teaching address
setting is completed.
A position data address was too high.
↑
↓ OFF when the next teaching command is
completed normally or teaching address
setting is completed.
0
Section 6-4
Page
164
---
164
165
165
165
166
166
167
167
---
---
168
168
169
169
167