Configuring An Lac; Configuring An Lac To Initiate Tunneling Requests For A Specified User - HP VSR1000 Layer 2 - Wan Access Configuration Manual

Configuring the local tunnel name—The local tunnel name identifies the tunnel at the local end
•
during tunnel negotiation between an LAC and an LNS.
To configure basic L2TP capabilities:
Step
1. Enter system view.
2. Enable L2TP.
3. Create an L2TP group, specify
its mode, and enter its view.
4. Specify the local tunnel name.

Configuring an LAC

An LAC establishes tunnels with LNSs and forwards packets between LNSs and remote systems.
Configuring an LAC to initiate tunneling requests for a specified
user
This task configures an LAC to initiate tunneling requests to an LNS for a specified user. When the PPP
user information matches the specified user, the LAC considers the PPP user to be an L2TP user and
initiates tunneling requests to the LNS.
You can specify a user by configuring one of the following:
Fully qualified name—The LAC initiates tunneling requests to the LNS only if the username of a PPP
•
user matches the configured fully qualified name.
Domain name—The LAC initiates tunneling requests to the LNS only if the ISP domain name of a
•
PPP user matches the configured domain name.
To configure an LAC to initiate tunneling requests for a specified user:
Step
1. Enter system view.
2. Enter L2TP group view in LAC
mode.
3. Configure the LAC to initiate
tunneling requests for a
specified user.
Command
system-view
l2tp enable
l2tp-group group-number
mode { lac | lns }
tunnel name name
Command
system-view
l2tp-group group-number [ mode
lac ]
user { domain domain-name |
fullusername user-name }
17
Remarks
N/A
By default, L2TP is disabled.
By default, no L2TP group exists.
Specify the mode as lac on the LAC side
and as lns on the LNS side.
Optional.
By default, the device name is used.
Remarks
N/A
N/A
By default, an LAC does not initiate
tunneling requests for any users.