Table of Contents
Advertisement
JR
BRAKES - BASE (Continued)
Dial Indicator C-3339
Tubes, Master Cylinder Bleed 8358
BRAKE FLUID LEVEL SWITCH
REMOVAL
(1) Remove wiring harness connector from brake
fluid reservoir level switch on the side of the reser-
voir (Fig. 2).
Fig. 2 BRAKE FLUID LEVEL SWITCH
1 - BRAKE FLUID LEVEL SWITCH
2 - WIRING CONNECTOR
3 - FLUID RESERVOIR
(2) Using a small screwdriver, release the retain-
ing tabs on the opposite end of brake fluid level
switch (on right side of reservoir) securing it to the
reservoir (Fig. 3).
(3) With retaining tabs compressed, grasp the con-
nector end of brake fluid level switch and pull it out
of master cylinder brake fluid reservoir.
Fig. 3 RETAINING TABS
1 - RETAINING TABS FOR FLUID LEVEL SWITCH
2 - RETAINING TABS FOR FLUID RESERVOIR
INSTALLATION
(1) Insert brake fluid level switch into left side of
brake fluid reservoir. Be sure switch is pushed in
until retaining tabs lock it to brake fluid reservoir.
(2) Connect vehicle wiring harness connector to
brake fluid level switch.
ASPIRATOR VALVE
DESCRIPTION
The aspirator valve is located in the vacuum hose
leading to the power brake booster from the engine
on V-6 equipped vehicles.
OPERATION
The aspirator valve helps improve vacuum assist
response in low vacuum situations.
REMOVAL
(1) Remove hose leading from vacuum source to
aspirator valve at valve.
(2) Remove hose leading to booster from valve.
(3) Remove hose leading to air cleaner housing
from valve and remove valve from vehicle.
INSTALLATION
(1) Install smaller port on brown half of aspirator
valve in hose leading to air cleaner housing.
(2) Install open port on black half of valve in hose
leading to power brake booster.
(3) Install larger port on brown half of valve in
hose leading from vacuum source.
BRAKES - BASE
5 - 5
Advertisement
Table of Contents
