Installation; Marker Lamp - Concorde Removal; Marker Lamp Unit - Concorde Removal; Multi-Function Switch Description - Chrysler 300M 2002 Service Manual

LH
LICENSE PLATE LAMP UNIT (Continued)

INSTALLATION

(1) Place license plate lamp in position on vehicle.
(2) Install screws to attach license plate lamp to
fascia.
MARKER LAMP - CONCORDE
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Reach under the fascia and remove the socket
from the side marker lamp housing (Fig. 35).
(3) Pull bulb from socket.
Fig. 35 FRONT SIDE MARKER LAMP - CONCORDE
1 - FOG LAMP
2 - SIDE MARKER
INSTALLATION
(1) Push bulb into socket.
(2) Install socket into front side marker lamp
housing.
(3) Connect the battery negative cable and close
hood.
(4) Verify park and front side marker lamp opera-
tion.
MARKER LAMP UNIT -
CONCORDE
REMOVAL
(1) Loosen fascia as necessary to access lamp.
(2) Remove bulb socket from lamp.
(3) Disconnect fasteners attaching side marker
lamp to fascia (Fig. 35).
(4) Remove attaching fasteners.
(5) Remove lamp unit from vehicle.
LAMPS/LIGHTING - EXTERIOR 8L - 27
INSTALLATION
(1) Place lamp in position on fascia.
(2) Install lamp fasteners.
(3) Install bulb socket in lamp.
(4) Connect wire harness connector.
(5) Verify lamp operation.
(6) Attach fascia to vehicle.
MULTI-FUNCTION SWITCH
DESCRIPTION
MULTI-FUNCTION SWITCH
Fig. 36 MULTI-FUNCTION SWITCH
1 - WINDSHIELD WASHER BUTTON
2 - CONTROL STALK (BEAM SELECT)
3 - HAZARD WARNING BUTTON
4 - MULTI-FUNCTION SWITCH
5 - WINDSHIELD WIPER CONTROL
The turn signals are part of the multi-function
switch (Fig. 36) which contains:
• Electrical circuitry for turn signals.
• Hazard warning switch.
• Headlamp beam select switch.
• Headlamp optical horn.
• Windshield wiper switch.
• Pulse wipe and windshield washer switching.
The integrated switch assembly is mounted to the
left hand side of the steering column.
HAZARD WARNING SYSTEM
The hazard warning system is actuated by a push
button located on the top of the steering column
between the steering wheel and the instrument panel
(Fig. 36). The hazard switch is identified with a dou-
ble triangle on top of the button.