Stapler Faults - Fuji Xerox DocuPrint C5005 d User Manual

6.2

Stapler Faults

A staple jam may occur when the finisher (optional) is installed to use the stapler. In such
case, check the message on the display and perform the procedures on the following
pages.
CAUTION
• Be careful in removing jammed staples.
Also, when printouts are not stapled or staples are bent, follow the procedures to clear the
staple jams. Contact our Customer Support Center if the problem persists after you have
tried the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support Center.
One side of staple rising up
240
6 Troubleshooting
Unstapled
Flattened staple
Staple bent in reverse direction
Entire staple rising up
Staple rising up with
center pressed in
Bent staple