CRUISE CONTROL SYSTEM
SERVICE ADJUSTMENT PROCEDURES
CRUISE CONTROL CABLES INSPECTION AND ADJUSTMENT
Cruise control actuator
II
Adjusting nut B
Throttle cable
Accelerator cable
Throttle valve
for inspection at no load.
(2) Let the engine warm up until it runs at idle.
(3) Check that the idle speed is within the specified range.
(4) Stop the engine and set the ignition switch to OFF.
(5) Check that the accelerator cable, cruise control cable and
throttle cable are routed without sharp bends.
(6) Depress the accelerator pedal to check that the throttle
lever moves smoothly from the fully-closed to fully-opened
position.
(7) Check the free travel state of the inner cables of the
accelerator cable, cruise control cable and throttle cable.
(8) If the inner cables are too loose or have no free travel at all,
check using the following procedure.
Cruise control assembly
Adjusting nut A
Link B
and intermediate links A, B and C to place the throttle
lever and intermediate links A, B and C in the free state.