Mitsubishi Stealth 1994 Import Service Manual page 857

MANUAL TRANSAXLE <FWD>
Post-installation Operation
Installation of Front Under Cover
l
(Refer to GROUP 23A- Front Bumper.)
Supplying of Transmission Oil (Refer to P.21-II.)
l
Filling of Engine Coolant (Refer to GROUP 7 -
l
Service Adjustment Procedures.)
Checking Operation of Shift Lever at Each Position
l
Checking the Operation of the Meters and Gauges
l
60-72 Nm
43 - 52 ftlbs.
I
14. Connection for transaxle mount
15. Transaxle mount bracket
l
+ 16. Mounting stopper
17. Transaxle assembly upper part
coupling bolt
18. Connection for transaxle ground cable
19. Connection for tie rod end
20. Connection for lower arm
ball joint
21. Right member
70 Nm
22. Starter
23. Drive shaft (Left side),
Inner shaft assembly
l
I) *C 24. Drive shaft (Right side)
25. Transaxle stay (Front bank side)
26. Transaxle stay (Rear bank side)
27. Transaxle assembly lower part
coupling bolt
28. Transaxle assembly
SERVICE POINTS OF REMOVAL
9. DISCONNECTION OF THE CLUTCH TUBE BRACKET
AND CLUTCH DAMPER ASSEMBLY
Remove the clutch release cylinder and clutch oil line
bracket installation bolt, and then secure at the body side
without disconnecting the oil line coupling.
20