Mitsubishi Stealth 1994 Import Service Manual page 406

INTAKE AND EXHAUST
REMOVAL AND INSTALLATION
l
Removal steps
2. Connection of accelerator cable
3. Throttle body assembly
l
+ 4. Throttle body gasket
5. Connection of vacuum hose
6. Connection of brake booster vacuum hose
7. Harness connector
8. EGR temperature sensor
9. EGR valve
16
<Vehicles for
California>
SERVICE POINT OF REMOVAL
3. REMOVAL OF THROlTLE BODY ASSEMBLY
With the water hoses and vacuum hoses as fitted, remove
from the intake manifold plenum.
INSPECTION
Check the following points; replace the part if a problem is
found.
INTAKE MANIFOLD PLENUM
if defective or cracked.
(2) Check load (negative pressure) of drain port. Clean if
required.
SERVICE POINT OF INSTALLATION
4. INSTALLATION OF THROTTLE BODY GASKET
Install with the gasket protrusion positioned as shown.
Caution
If installed in an incorrect direction, idling failure or
other problems may occur.
11. EGR pipe installation bolts
12. EGR pipe gasket
13. Connection of intake manifold plenum stay
14. Intake manifold plenum installation bolts
15. Intake manifold plenum installation nuts
16. Intake manifold plenum
17. Intake manifold plenum gasket
<Vehicles for
California>