Mitsubishi Stealth 1994 Import Service Manual page 859

MANUAL TRANSAXLE <FWD>
part of drive shaft
Transaxle
mount
bracket
Water Inlet
24. REMOVAL OF DRIVE SHAFT (RIGHT SIDE)
assembly, apply pry bar to the protrusion.
NOTE
Remove drive shaft (right side) as an assembly together
with hub, knuckle, and other parts.
(2) Suspend the removed drive shaft (right side) with wire
or something similar to prevent it from sharply bending
or turning at each joint.
27. REMOVAL OF TRANSAXLE ASSEMBLY LOWER PART
COUPLING BOLT / 28. TRANSAXLE ASSEMBLY
Support transaxle assembly with a transaxle jack and
remove transaxle assembly lower part coupling bolt; then,
lower transaxle assembly.
SERVICE POINTS OF INSTALLATION
24. INSTALLATION OF DRIVE SHAFT (RIGHT SIDE)
Provisionally install the drive shaft (right side) so that the
inboard joint part of the drive shaft (right side) is straight,
and not bent relative to the transaxle.
Caution
Care must be taken to ensure that the oil seal lip part of
the transaxle is not damaged by the serrated part of the
drive shaft (right side).
16. INSTALLATION OF MOUNTING STOPPER
Install mounting stopper in the direction shown.
7. CONNECTION OF WATER INLET PIPE B <SOHC>
Install the O-ring to the water inlet pipe B, apply water to
the outer circumference of the O-ring and connect the pipe
B to the water inlet pipe A.
Caution
Take care not to smear the O-ring with the engine oil or
the like.