Mitsubishi Stealth 1994 Import Service Manual page 1165

WHEN DIAGNOSTIC TROUBLE CODE No. 41 IS DISPLAYED )
WHEN DIAGNOSTIC TROUBLE CODE No. 42 IS DISPLAYED 1
I
, FUSIBLE,LINK@
IGNITION SWITCH(IG1)
Battery
SRS
J/B
(1) Turn the ignition key to the "LOCK" position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. The SRS system is
designed to retain enough voltage to deploy the air bag
even after the battery has been disconnected. Serious
injury may result from unintended air bag deployment
if work is done on the SRS system immediately after
the battery cable is disconnected.
(2) Remove the rear console assembly. (Refer to GROUP 23A
(3) Apply a flat tip screwdriver to the lock spring (metallic
portion) of the SDU connector lock lever as illustrated and
push it horizontally toward the back of the unit.
Caution
1. Do not push up the lock lever (green) by force.
2. Never insert a screwdriver between the lock lever
(green) and the lock spring (metallic portion).
(4) Disconnect the red l&pin connector from the SDU.
SRS diagnosis unit
View A
Unused terminals
To passenger's air bag module
To ciock spring
To body wiring harness (14.pin)