Mitsubishi Stealth 1994 Import Service Manual page 737

CRUISE CONTROL SYSTEM
Control switch
L
CRUISE CONTROL SETTING CHECK
(1) Switch ON the main switch.
(2) Drive at the desired speed within the range of approximate-
ly 40 - 200 km/h (25 - 124 mph).
(3) Operate the control switch downward. (SET switch: ON)
(4) Check to be sure that the speed is the desired constant
speed when the switch is released, and also check to be
sure that the CRUISE indicator light (within the combination
meter) illuminates.
ON
NOTE
If the vehicle speed decreases to approximately 15 km/h (9
mph) below the set speed, because of climbing a hill for
example, the cruise control will be cancelled.
SPEED-INCREASE SETTING CHECK
(2) Operate the control switch upward. (RESUME switch: ON)
(3) Check to be sure that acceleration continues while the
switch is held, and that when it is released the constant
speed at the time when it was released becomes the
driving speed.
NOTE
Even if, during acceleration, the vehicle speed reaches or
exceeds the high limit [approximately 200 km/h (124 mph)],
acceleration will continue, however, when the switch is
released, the set speed ("memorized speed") will become
the high limit of the vehicle speed.
SPEED REDUCTION SETTING CHECK
(2) Operate the control switch downward. (SET switch: ON)
(3) Check to be sure that deceleration continues while the
switch is held, and that when it is released the constant
speed at the time when it was released becomes the
driving speed.
NOTE
When the vehicle speed reaches the low limit [approx-
imately 40 km/h (25 mph)] during deceleration, the cruise
control will be cancelled.
CRUISE CONTROL CANCELLATION AND SET SPEED RE-
SUME CHECK
(1) Set cruise control.
(2) In the cruising condition of the cruise control mode, check
that when any of the following operations are performed,
the normal drive mode is restored and the vehicle coasts
smoothly.
NCEL