Mitsubishi Stealth 1994 Import Service Manual page 433

INTAKE AND EXHAUST
REMOVAL AND INSTALLATION
Removal steps
1. Active exhaust system control module
2. Connection of cable (Actuator side)
3. Actuator
4. Protector
l
* 5. Connection of cable (Muffler :side)
6. Cable
Adjusting nuts
Removal and Installation of Rear Side Trim (LH)
l
(Refer to GROUP 23A-TRIMS.)
SERVICE POINTS OF INSTALLATION
5. INSTALLATION OF CABLE (Muffler Side)
Install with the paint mark facing up and adjust the adjusting
nut to obtain the illustrated dimension.
2. INSTALLATION OF CABLE (Actuator Side)
After adjusting the cable on the muffler side, adjust the
adjusting nuts for an inner cable play of 0 to 1 mm (0 to .04
in.).