Mitsubishi Stealth 1994 Import Service Manual page 954

21-114
AUTOMATIC TRANSAXLE - s ervice Adjustment Procedures
Mounting bolt
Section A-A
Manual
control
(4) Loosen nut that secure key interlock cable.
(5) Lightly pressing lock cam A in the direction of arrow,
(6) Reinstall front console assembly.
SHIFT LOCK MECHANISM CHECK
Check to be sure that, under the following conditions, the
Brake
selector lever cannot be moved from the "P" position to
any other position.
Ignition key position: "ACC"
Brake pedal: Not depressed
Button: Pressed
2 Check to be sure that, under the following conditions, the
selector lever can be moved smoothly from the "P"
position to any other position.
Ignition key position: "ACC"
Brake pedal: Depressed
Button: Pressed
Brake
3.
Check to be sure that, under the following conditions, the
selector lever can be moved smoothly from the "R"
position to the "P" position.
ignition key position: "ACC"
Brake pedal: Released
Button : Pressed
4. If a malfunction is discovered when following the above
checking procedures, either adjust or check the shift lock
cable mechanism. (Refer to P.21-118.)
Manual
PARK/NEUTRAL POSITION SWITCH AND CON-
control lever
TROL CABLE ADJUSTMENT
2. Place manual control lever in "N" (Neutral) position.
3. For adjustment, turn park/neutral position switch body so
that the end (section A-A in illustration on left) of manual
control lever is aligned with the hole in park/neutral position
switch body flange.
4. Tighten the mounting bolts of the park/neutral position
TFA0359
switch body to the specified torque. At this time, take care
to prevent dropping the switch body.
Specified torque: 10 - 12 Nm (7 - 9 ft.lbs.)
,
Switch
body
lightly push key interlock cable to take up slack and
tighten nut to secure key interlock cable.