Mitsubishi Stealth 1994 Import Service Manual page 969

AUTOMATIC TRANSAXLE
DISASSEMBLY
Caution
1. The automatic transaxle consists of high-precision
2. Place a rubber mat on the workbench and keep it clean
3. Do not use cotton work gloves or waste cloth for the
4. Clean all disassembled parts. Commercially available
5. Clean the clutch disc, plastic thrust plates, and rubber
6. If the transaxle is damaged, the cooler system should
(1) Remove the torque converter.
(2) Install the dial indicator to the transaxle case and measure
(3) Remove brackets.
(4) Remove the oil level gauge and oil level gauge guide.
(5) Remove pulse generators A and B
(6) Remove the manual control lever and then remove the
(7) Remove the speedometer drive gear assembly.
parts and utmost care must be exercised during
disassembly and reassembly to prevent damage to the
parts.
at all times.
disassembly job. Use nylon cloth or paper towel if
necessary.
detergent may be used to clean the metallic parts;
however, be sure to dry them completely with air.
parts with ATF (automatic transmission fluid) to pre-
vent adhesion of dust and dirt.
also be disassembled and cleaned.
the end play in the input shaft.
park/neutral position switch.
21-129