Mitsubishi Stealth 1994 Import Service Manual page 1174

SRS - Component Service / Front Impact Sensors
If the SRS components are to be removed or replaced as a result of maintenance, troubleshooting, etc.,
follow each procedure (P.23B-48 - P.23B-60).
Caution
components
1. SRS
sensors, SRS diagnosis unit, air bag modules and clock spring before drying or baking the vehicle
after painting. Recheck SRS system operability after re-installing them.
2. If the SRS components are removed for the purpose of inspection, sheet metal repair, painting,
etc., they should be stored in a clean, dry place until they are reinstalled.
Caution
1. Never repair or disassemble a front impact
sensor. If faulty, replace it.
2. Handle the front impact sensors very careful-
subject them to impact. If a sensor is seen to
REMOVAL AND INSTALLATION
Removal steps
l 4
Post-installation inspection
1. Connection for the negative (
cable
2. Front splash shield extension
l
C 3. Front impact sensor
l 4
Pre-installation inspection
should not be subjected to heat over 93°C (2Oo"F), so remove the front impact '0
3