Mitsubishi Stealth 1994 Import Service Manual page 351

ENGINE
Reamer bolt
MD998754
SERVICE POINTS OF REMOVAL
7. DISCONNECTION OF POWER STEERING OIL PUMP
Disconnect the oil pump (with the hose attached).
NOTE
Suspend the removed oil pump (by using wire or similar
material) at a place where no damage will be caused during
removal/installation of the engine assembly.
8. REMOVAL OF ENGINE SUPPORT BRACKET
Remove the engine support bracket in the numbered
sequence shown in the illustration.
Spraying lubricant, slowly remove the bolt (reamer bolt)
indicated by the arrow.
Caution
Keep in mind that the reamer bolt is sometimes heat
seized on the engine support bracket.
NOTE
Slightly jack up the engine body to make work easier.
9. REMOVAL OF CRANKSHAFT PULLEY
Using the special tool, remove the crankshaft pulley from
the crankshaft.
15. REMOVAL OF TIMING BELT
(1) Align the timing marks.
(2) Make a mark on the back of the timing belt indicating
the direction of rotation so it may be reassembled in the
same direction if it is to be reused.
(3) Loosen the bolt of the timing belt tensioner.
(4) Using a screwdriver or the like, turn the timing belt
tensioner counterclockwise and tighten the tensioner
bolt.
(5) Remove the timing belt.