Mitsubishi Stealth 1994 Import Service Manual page 866

21-26
MANUAL TRANSAXLE <FWD>
Slit
48.49. INSTALLATION OF SPRING PINS
punch.
Caution
Do not reuse the spring pins.
(2) When installing, make sure that the slit of the spring pin
is aligned with the shift rail center line.
46. INSTALLATION OF REVERSE IDLER GEAR SHAFT
Install in the direction illustrated.
35.37. 40. 42. INSTALLATION OF SPACERS
(1) Place two pieces of solder measuring about 10 mm (.4
er
in.) in length and 1.6 mm (.06 in.) in diameter as
illustrated and install the outer races.
(2) Install the transaxle case and tighten the bolts to
specified torque.
(3) Remove the transaxle case.
(4) Remove the outer races and remove the solder.
(5) If solder is not crushed, perform steps (1) to (4) with a
solder with a larger diameter.
(6) Measure the thickness of the crushed solder with a
micrometer and select and install a spacer of thickness
that gives standard preload and end play.
Standard value:
Input shaft end play
0 - 0.05 mm (0 - .002 in.)
Intermediate gear preload
0.05 - 0.10 mm (.002 - .004 in.)
Output shaft preload
0.05 - 0.10 mm (.002 - .004 in.)
Differential case preload
0.05 - 0.10 mm (.002 - .004 in.)