Mitsubishi Stealth 1994 Import Service Manual page 1160

Insulating tape
Battery (-1 cable
Resistor
MB991 530
SRS check harness
CONTINUED ON NEXT PAGE
SRS - Troubleshooting
nect the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the
battery cable before doing any further work. The
SRS system is designed to retain enough voltage to
deploy the air bag even after the battery has been
disconnected. Serious injury may result from unin-
tended air bag deployment if work is done on the
SRS system immediately after the battery cable is
disconnected.
(2) Disconnect the passenger's air bag module connector
from the body wiring harness connector.
(3) Connect the SRS check harness connector @ to the
body wiring harness connector.
NOTE
A 3-ohm resistor that corresponds to the resistance of
the passenger's air bag module (squib) and the wiring
resistance is connected between the terminals of the
connector @ of the SRS Check Harness.