Mitsubishi Stealth 1994 Import Service Manual page 354

TIMING BELT <DOHC>
REMOVAL AND INSTALLATION
Pre-removal Operation
Removal of the Under Cover (Front L.H.,
l
side L.H.)
Removal of Cruise Control Pump and
l
<Vehicle with Cruise Control>
(Refer to GROUP 14-Cruise Control.)
Removal of Generator Assembly
l
(Refer to GROUP 8- Engine Electrical.)
Raise and Suspend the Engine to the Extent
l
Force is not Applied to the Engine Mount
50 Nm
36 ft.lbs.
76
Removal steps
1. Air hose
2. Air pipe
3. Tensioner assemblv
4. Drive belt (power steering)
(Refer to P.9-16.)
5. Crankshaft pulley
+
l
6. Brake fluid level sensor
7. Timing belt upper cover
8. Engine mount bracket
9. Idler pulley (generator/air conditioning)
* ** IO. Engine support bracket
l
position sensor connector
* 12. Timing belt lower cover
l
l c Adjustment of timing belt tension
+ 13. Timing belt
l
C 14. Auto tensioner
l
ENGINE
I O - 1 2 N m
7 - 9 ft.lbs.
72 - 87 ft.lbs.
12 Nm
70 NI
9 ftlbs.
4
SERVICE POINTS OF REMOVAL
5. REMOVAL OF CRANKSHAFT PULLEY
Using the special tool, remove the crankshaft pulley from
the crankshaft.
Caution
Use only the specified special tools, or a damaged 'd
pulley damper could result.
I O - 1 2 N m
7 - 9 ft.lbs.
1
31 l-
2.9 ftlbs.
2.9 ft.lbs.
Post-installation Operation
Installation of Generator
l
(Refer to GROUP 8 ~ Engine Electrical.)
Installation of the Under Cover
l
(Front L.H.. Side L.H.)
l
<Vehicle with Cruise Control>
(Refer to GROUP 14 -Cruise Control.)
Adjustment of the Engine (Refer,to P.9-16.)
l
I O - 1 2 N m
7 - 9 fklbs.
7