Mitsubishi Stealth 1994 Import Service Manual page 362

9-64
Division = 1 mm (.04 in.)
Rocker arm shaft (B)
Front mark
Bearing dap No.
ENGINE
(4) After air bleeding, set lash adjuster on the special tool (Leak
down tester M D998440).
(5) After plunger has gone down somewhat 0.2 - 0.5 mm (.008
in.). Replace if measured time is out of specification.
Standard value: 4 - 20 seconds / 1 mm (.04 in.)
[Diesel fuel at 15 - 20°C (50 - 68"F)]
SERVICE POINTS OF INSTALLATION
29. INSTALLATION OF ROCKER ARM SHAFT (A) / 28.
ROCKER ARM SHAFT (B)
Insert bearing cap No.1 so that the notch on the end of the
shaft faces in the direction shown in the illustration and
insert the mounting bolt.
NOTE
Check that the oil groove faces downward as shown in the
illustration and the oil port is located on the rocket shaft (A)
side.
Rocker arm
23.18. 13. INSTALLATION OF BEARING CAP
Install the bearing caps so that the arrow marks on the caps
point in the same direction as the mark on the No.1 bearing
cap.
No.2 and 3 bearing caps are very similar in shape. Check the
stamped cap numbers for correct installation.