Mitsubishi Stealth 1994 Import Service Manual page 1163

MB991 530
View A
SRS Check Harness connector
Ground
I .
between the No. 19
Is there continuity
Harness connector
@and ground?
Reconnect negative terminal of
battery, and turn the ignition
key to the "ON" position.
Does the voltage between the No. 10
terminal (of SRS Check Harness connec-
tor 0) and the No. 19 or 20 terminal
NOTE - IMPORTANT
(1) If more than 45 seconds of cranking is required to start up the engine, the diagnostic trouble code
will be stored in memory, but if there is no problem, the diagnostic trouble code will be cleared
and the SRS will return to normal.
(2) After repairing the SRS, reconnect the battery cable, and check the SRS warning light operation to
verify the system functions properly. (Refer to TEST 1.)
(3) SDU = SRS Diagnosis Unit
SRS - Troubleshooting
(5) Connect the now disconnected red harness-side SDU
connector (14-pin) to the connector @ of the SRS Check
Harness.
(6) Check according to the flow chart below, using the digital
multi-meter.
I
, No I I
to the "LOCK" po-
sition, disconnect
the negative battery
cable and tape the
terminal.
(2) After waiting at least
60 seconds, repair or
I