24-22
HEATERS AND MANUAL AIR CONDITIONING
RESISTOR, BELT LOCK CONTROLLER
REMOVAL AND INSTALLATION
Removal steps
1. Stopper
2. Glove box outer case assembly
3. Resistor
4. Under cover
5. Belt lock controller <DOHC>
INSPECTION
RESISTOR CHECK
Using a circuit tester, measure the resistance between the
terminals indicated below.
The condition can be considered satisfactory if the value
measured at this time is equivalent to the standard value.
Standard value
Terminals measured
Between terminals @- @
Between terminals @ - @
Between terminals @ ~ @
Standard value fi
Approx. 1.79 ~ 2.06
Approx. 1 .I 0 - 1.26
Approx. 0.38 - 0.44