Mitsubishi Stealth 1994 Import Service Manual page 1207

HEATERS AND MANUAL AIR CONDITIONING -
Valve open
Valve close
(Refrigerant
Quick joint (for
container)
low pressure)
I -
Low pressure
,
CORRECTING LOW REFRIGERANT LEVEL IN CASE THE
SERVICE CAN IS USED
out (valve open) of the service can.
(2) Install the adaptor valve with the handle turned all the way
back (valve close) to the charging valve.
(blue)
(3) Connect the charging hose (blue) to the adaptor valve.
(4) Connect the charging hose (blue) to the quick joint (for low
pressure).
(5) Tighten the handle of the charge valve (valve close), and
pierce the service can.
(6) Turn the handle of the adaptor valve to bleed the air.
(7) Install the quick joint (for low pressure) to the low pressure
service valve.
NOTE
The low-pressure service valve should be connected to the
low-pressure hose.
Quick lolnt (for
(8) Start the engine.
(9) Operate the air conditioner and set at the lowest tempera-
ture (MAX. COOL).
valve
replenish refrigerant checking the quantity through- the
sight glass.
Caution
If the service can is inverted, liquid refrigerant may be
draw into the compressor damaging it by liquid
compression. Keep the service can upright to ensure
that refrigerant is charged in gas state.
adaptor valve all the way back (valve close), and remove the
quick joint.
NOTE
If any refrigerant is remaining in the service can, close the
adaptor valve,and save the refrigerant for another vehicle.
Do not release into the atmosphere.
Service Adjustment Procedures 24 15