Mitsubishi Stealth 1994 Import Service Manual page 1002

AUTOMATIC TRANSAXLE
DISASSEMBLY AND REASSEMBLY
Disassembly steps
1. Thrust bearing
l l
2. Rivet
* C
l
3. Waved washer
a
4. One-way clutch outer race
5. End plate
l
C 6. One-way clutch
7. End plate
8. Planet carrier
SERVICE POINTS OF REASSEMBLY
6. INSTALLATION OF SNAP RING
Using the special tool, fit the snap ring.
Caution
Make sure that the snap ring is fitted in position in the d
groove.
2. SELECTION OF SNAP RING
After the snap ring has been installed, check to see if the
clearance between the snap ring and clutch reaction plate is
up to specification. When measuring the clearance, press
the entire periphery of the clutch reaction plate with a force
of 50 N (11 Ibs.). If the clearance is out of specification,
reselect the snap ring to obtain the specified clearance.
Standard value: 0.6 - 0.85 mm (.024 - .033 in.)
•l
SERVICE POINT OF DISASSEMBLY
2. REMOVAL OF RIVET
does not hit it.
NOTE
Make sure that the stopper plate claw is not located at
the groove in the one-way clutch outer race.
8
,
TFA0491