Mitsubishi Stealth 1994 Import Service Manual page 1213

HEATERS AND MANUAL AIR CONDITIONING
INSPECTION
BLOWER SWITCH
Operate the switch, and check the continuity between the
terminals.
Terminal
NOTE
O-O indicates that there is continuity between the terminals.
SERVICE POINTS OF INSTALLATION
Connect the temperature control wire to the blend air
damper lever by following the steps below.
position. ("HOT" position)
(2) With the blend air damper lever pressed completely
downward in the direction indicated by the arrow,
connect the inner cable of the temperature control wire
to the end of the blend air damper lever, and then
secure the outer cable by using a clip.
9. INSTALLATION OF MODE SELECTION CONTROL WIRE
Connect the mode selection control wire to the mode
selection damper lever by following the steps below.
(1) Move the mode selection lever to the I$ position.
(2) With the mode selection damper lever pressed inward
in the direction indicated by the arrow, connect the
inner cable of the mode selection control wire to the
end of the mode selection lever, and then secure the
outer cable by using a clip.
3. INSTALLATION OF AIR SELECTION CONTROL WIRE
Connect the air selection control wire to the air selection
damper lever by following the steps below.
(2) Set the air selection damper lever as it contacts
stopper.
(3) Connect the inner cable of the air selection control wire
to the end of the air selection lever, and then secure the
outer cable by using a clip.
3 3
7 8
1
4