Mitsubishi Stealth 1994 Import Service Manual page 459

MULTIPORT FUEL INJECTION
READ OUT OF DIAGNOSTIC TROUBLE CODE
Precautions for Operation
(1) When battery voltage is low, no detection of failure is
(2) Diagnostic item is erased if the battery or the engine control
(3) Be sure to connect or disconnect the scan tool with the
When using the scan tool
(1) Connect the scan tool to the data link connector.
(2) Turn the ignition switch to ON.
(3) Take a reading of the diagnostic output.
(4) Repair the problem location, referring to the diagnostic
(5) After turning the ignition switch once to OFF, turn it back to
(6) Erase the diagnostic trouble code.
(7) Recheck to be sure that the condition is normal.
When using the check engine/malfunction indicator lamp
(1) Using the special tool (Diagnostic Trouble Code Check
(2) Turn the ignition switch to ON.
(3) Read the diagnostic output by blinking of the check
(4) Repair the problem location, referring to the diagnostic
(5) Erase the diagnostic trouble code by the following proce-
possible. Be sure to check the battery for voltage and other
conditions before starting the test.
module connector is disconnected. Do not disconnect the
battery before the diagnostic result is completely read.
ignition switch turned off. If the scan tool is disconnected
with the ignition switch placed in the ON position, ABS
diagnostic trouble code may be stored and ABS warning
lamp turned on.
Caution
Connection and disconnection of the scan tool should
always be made with the ignition switch in the OFF
position.
chart.
ON.
Harness), ground the diagnostic test mode control terminal
(terminal 1) of the data link connector.
engine/malfunction indicator lamp.
chart.
dure.
terminals for 10 seconds or more, reconnect the cable.
diagnostic output to check if a normal code is output.