Mitsubishi Stealth 1994 Import Service Manual page 754

PROPELLER SHAFT AND UNIVERSAL JOINTS - Propeller Shaft
race
race
Caae
15. REMOVAL OF CENTER BEARING ASSEMBLY
First remove the center bearing bracket and then remove
the center bearing using a puller (commercially available).
INSPECTION
Check the propeller shaft splines for wear or damage.
l
Check the ball grooves in inner or outer race for uneven
l
Check ball surface for rust, wear or other damage.
l
Check the cage for rust or damage.
l
1 0 X 0 0 1 8
SERVICE POINTS OF REASSEMBLY
Rubber mount
15. INSTALLATION OF CENTER BEARING ASSEMBLY / 14.
COMPANION FLANGE / 13. SELF-LOCKING NUT
(2) Install the center bearing assembly to the rear propeller
(3) Install, lining up the mating marks on the companion
(4) While tightening the self-locking nut, install the center
Tape the serration of the center propeller shaft and then
install the Lobro joint boot.
8. INSTALLATION OF LOBRO JOINT ASSEMBLY
Assemble the Lobro joint as follows:
center bearing bracket.
shaft with its dust seal facing the companion flange
side.
flange and the rear propeller shaft.
bearing assembly with the companion flange.
grooves of the inner and outer races.
Specified grease: Repair kit grease