Mitsubishi Stealth 1994 Import Service Manual page 1154

CONTINUED FROM PREVIOUS PAGE
MB991 530
SRS Check Harness
Resistor (3fi)
I
Clock spring
I
CONTINUED ON 23B-31 *
(TEST 6)
N O T E - IMPORTANT
from the scan tool and check the SRS warning light operation to verify the system functions
properly. (Refer to TEST 1.)
(2) SDU = SRS Diagnosis Unit
SRS
Harness to the SDU in place of the now-disconnected
clock spring-SDU connector and passenger's air bag
modole-SDU connector.
NOTE
A 3-ohm resistor that corresponds to the resistance of
the air bag module (squib) and the wiring resistance is
connected between the terminals of the connector @
of the SRS Check Harness.
(2) Reconnect 14-pin red connectors, for the wiring leading
to the front impact sensors, to the SDU and double lock
them. (Refer to P.23B-9.)
NOTE
If double locking cannot be made, the connector is
incorrectly or incompletely inserted; re-check to insert
the connector correctly and securely.
,
I
Passenger's
air bag module
CONTINUED ON 23B-35 *
(TEST 7)