Mitsubishi Stealth 1994 Import Service Manual page 348

ENGINE - ~Cylinder Head Gasket <DOHC>
SERVICE POINTS OF REMOVAL
6. REMOVAL OF INTAKE CAMSHAFT SPROCKET
(2) Remove the camshaft sprockets.
14. REMOVAL CYLINDER HEAD ASSEMBLY
Using a IO mm hex wrench, remove the cylinder head
assembly.
NOTE
Use of commercially available cylinder head bolt wrench is
recommended.
SERVICE POINTS OF INSTALLATION
15. INSTALLATION OF CYLINDER HEAD GASKET
(2) Lay the cylinder head gasket on the cylinder block with
14. INSTALLATION OF CYLINDER HEAD ASSEMBLY
(1) Use a scraper to clean the gasket surface of the cylinder
(2) Using a 10 mm hex wrench and a torque wrench,
(3) Back off the bolts once and tighten them to the
NOTE
Use of commercially available cylinder head bolt wrench is
recommended.
Front
bank
remove the camshaft sprocket bolt.
Caution
Locking the camshaft sprocket with a tool damages
the sprocket.
mark for the engine.
the identification mark at the front top.
head assembly.
Caution
Take care that no foreign material gets into the
cylinder, coolant passages or oil passages.
tighten the bolts to the specified torque in the order
shown in the illustration. (in two or three cycles)
Caution
Install the head bolt washers with shear droop
upward as shown in the illustration.
specified torque as shown in step (2). <Turbo>