Mitsubishi Stealth 1994 Import Service Manual page 1219

HEATERS AND MANUAL AIR CONDITIONING
EVAPORATOR
REMOVAL AND INSTALLATION
Compressor oil:
SUN PAG 56
Removal steps
1. Connection of liquid pipe C and low-pressure
hose B
2. O-ring
3. Drain hose
4. Stopper
5. Glove box
6. Glove box outer case assembly
7. Under cover
8. Lower frame
9. A/C control unit
l + 10. Evaporator
Pre-removal and Post-installation Operation
Discharge and Charging of Refrigerant
l
Removal and lns~allation of Battery
l
SERVICE POINTS OF REMOVAL
1. DISCONNECTION OF LIQUID PIPE C AND LOW-
PRESSURE HOSE B
If the hoses or pipes are disconnected, cap the hoses or
pipes with a blank plug to prevent entry of dust, dirt, and
water.
INSPECTION
Check for damage of the evaporator fin part.
l
Check for damage or collapse of the drain hose.
l
Check for peeling or cracking of the insulator.
l
FIN-THERM0 SENSOR AND AIR-INLET SENSOR CHECK
For information concerning the checking procedures, refer to
SERVICE POINT OF INSTALLATION
If a new evaporator is used, fill it with the specified amount of
compressor oil before installing on the vehicle.
Compressor oil: SUN PAG 56
Quantity: 60 cm3 (2.0 fl.oz.)
24-27
9-11 Nm