Mitsubishi Stealth 1994 Import Service Manual page 1175

Digital multi-meter
SRS - Front Impact Sensors
SERVICE POINTS OF REMOVAL
1. DISCONNECTION OF THE NEGATIVE (-) BATTERY
CABLE FROM THE BATTERY
Turn the ignition key to the "LOCK" position, disconnect
the negative battery cable from the battery and tape the
terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. The SRS system is
designed to retain enough voltage to deploy the air bag
even after the battery has been disconnected. Serious
injury may result from unintended air bag deployment
if work is done on the SRS system immediately after
the battery cable is disconnected.
INSPECTION
rust.
(2) Check sensor harness for binds, connectors for damage,
and terminals for deformities.
(3) Check for dents, cracks or deformation of the front impact
sensor.
Caution
If a dent, crack, deformation or rust is detected, replace
with a new sensor.
(4) Remove the front impact sensor.
(5) Measure the resistance between terminals and check
whether it is within the standard value.
Standard value: 2,000 & 40 R
Caution
Always replace the sensor with a new one if the
resistance is not within the standard value.