Mitsubishi Stealth 1994 Import Service Manual page 1191

SRS
Wires
Module Disposal Procedures
<Passenger's side>
1. Remove the passenger's air bag module.
(Refer to P.23B-55.)
Caution
The air bag module should be stored on a flat
surface and placed so that the pad cover face up. Do
not place anything on top of it.
2. Connect two wires each six meters (20 feet) long or
more, to the two leads of SRS AIR BAG ADAPTER
HARNESS A and cover the connections with insulation
tape. The other ends of the two wires should be
connected to each other (short-circuited), to prevent
sudden unexpected deployment of the air bag.
3. Connect the deployment wires to the SRS air bag
adapter harness A, pass it beneath the tire and wheel
assembly and connect it to the air bag module.
4. Pass the thick wires into the hole of the air bag module
bracket, a,nd secure it to the wheel of the old tire with
wheel (4 locations), with the air bag facing upwards.
Caution
1. Leave some space below the wheel for the
deployment wires.
If there is no space, the reaction of the air bag
deployment could result in damage of the
adapter harness.
2. While deployment takes place, do not have the
connector of the SRS air bag adapter harness A
inserted between the tires.
5. Place three old tires without wheels on top of the tire
secured to the air bag module, and secure all tires with
ropes (4 locations).