Mitsubishi Stealth 1994 Import Service Manual page 1166

MB991 530
SRS Check Harness
View A
SRS Check Harnessconnector (5)
Fuse No. 18 Ground
Is there continuity between the No. 19
or No. 20 terminal of SRS Check
Harness connector @ and ground?
Reconnect negative terminal of
Is there a voltage of 9V or more
between the No. 19 or 20
terminal (ground) and
the No. 12 terminal of the SRS
Check Harness connector @?
Yes
Yes
Is there a voltage of 9 V or more between
the No. 19 or 20 terminal (ground) and
the No. 11 terminal of the SRS Check
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, and check the SRS warning light operation to
verify the system functions properly. (Refer to TEST 1.)
(2) SDU = SRS Diagnosis Unit
SRS
(5) Connect the now disconnected red harness-side SDU
connector (14-pin) to the connector @ of the SRS Check
Harness.
(6) Check according to the flow chart below, using the digital
multi-meter.
Fuse
No. 11
No
ing of fuse No. 18, or damaged
or disconnected body wiring
harness.
Damaged or disconnected wir-
ing of fuse No. 11, or damaged
or disconnected body wiring
harness.
to the "LOCK" po-
sition, disconnect
the negative battery
cable and tape the
terminal.
(2) After waiting at least
60 seconds, repair or
replace the body wir-
ing harness. (Refer to
(Refer to P.23B-51)
to the "LOCK" po-
sition, disconnect
the negative battery
cable and tape the
terminal.
(2) After waiting at least
60 seconds, replace
the SDU. (Refer to