Mitsubishi Stealth 1994 Import Service Manual page 1169

WHEN DIAGNOSTIC TROUBLE CODE No. 43 IS DISPLAYED
TEST 13
(SRS warning light does not illuminate)
IGNITION SWITCH(IG1)
I
Insulating tape
Battery
COMBINATION METER
Battery (-) cable
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. The SRS system is
designed to retain enough voltage to deploy the air bag
even after the battery has been disconnected. Serious
injury may result from unintended air bag deployment
if work is done on the SRS system immediately after
the battery cable is. disconnected.
(2) Remove the rear console assembly. (Refer to GROUP 23A
(3) Apply a flat tip screwdriver to the lock spring (metallic
portion) of the SDU connector lock lever as illustrated and
push it horizontally toward the back of the unit.
Caution
1. Do not push up the lock lever (green) by force.
2. Never insert a screwdriver between the lock lever
(4) Disconnect the red 14-pin connector from the SDU.
1
View A
Unused terminals
To clock spring
Floor Console.)
(green) and the lock spring (metallic portion).
SRS diagnosis unit
To passenger's air bag module
To body wiring harness (14-pin)