Mitsubishi Stealth 1994 Import Service Manual page 1159

WHEN DIAGNOSTIC TROUBLE CODE No.
I 5
Have the other diagnostic trouble code
test(s) been finished?
CONTINUED ON NEXT PAGE
SRS
PASS NGER'S
A I R &&fDULE
No .
trouble code test(s) prior to
I
this test.
NOTE
If combined front impact sensor and passenger's air bag module (squib) failure modes
simultaneously occur in two places, the preconditions for the respective detection circuits
will go out of order. For this reason, both diagnostic trouble codes may not be stored but
only one of them may be indicated.
Their relationships are shown in the following table.
Perform p/ if it does not become proper even through ml is executed.
Passenger's Short-circuited
air bag
module Open-circuited
The numbers in the boxes are diagnostic trouble codes numbers. (Refer to P.23B-19.)
I
OR No. 25 IS DISPLAYED
24
Caution
Never attempt to measure the circuit resistance of
the passenger's air bag module (squib) even if you
are using the specified tester. If the circuit resistance
is measured with a tester, accidental driver's air bag
deployment will result in serious personal injury.
View A
Unused terminals
To cl&k spring
Front impact sensors
Short-circuited One open-circuited Two open-circuited
12 or 24
11 or 24
12 or 25
11 or 25
passenger's air bag module
To
To body wiring harness (14.pin)
13 or 24
13 or 25