Mitsubishi Stealth 1994 Import Service Manual page 886

21-46
MANUAL TRANSAXLE <FWD>
The numerals @to @ Indicate
the tightening sequence.
SPEEDOMETER DRIVEN GEAR ASSEMBLY
DISASSEMBLY AND REASSEMBLY
Lubricate all
internal parts
with gear oil
during reassembly.
Disassembly steps
1. O-ring
l
* 2. Spring pin
l Speedometer driven
4 3.
4. Oil seal
5. Sleeve
3. INSTALLATION OF TAPER ROLLER BEARING
Install the taper roller bearings on both sides of the
differential case.
Caution
When press-fitting the bearings, push the inner race
only.
1. INSTALLATION OF BOLTS
Apply specified adhesive to the entire threads of the bolts
and quickly tighten in the order shown to specified torque.
Specified adhesive: MOPAR Part No. 4318031 or
Caution
If a bolt is reused, remove traces of oil adhesive
completely from the threads.
gear
SERVICE POINTS OF REASSEMBLY
3. INSTALLATION OF SPEEDOMETER DRIVEN GEAR
Apply gear oil sparingly to the speedometer driven gear
shaft and insert the shaft.
2. INSTALLATION OF SPRING PIN
Install the spring pin in such a way that its slit does not face
the gear shaft.
MOPAR Part No. 4318032 or
equivalent
201078