Mitsubishi Stealth 1994 Import Service Manual page 809

STEERING - Steering Wheel and Shaft
INSPECTION
Check the steering shaft for play and round movement.
l
Check the joint bearing for wear and damage.
l
Check the dust shield for damage.
l
SERVICE POINTS OF REASSEMBLY
7. INSTALLATION OF STEERING LOCK CYLINDER / 6.
STEERING LOCK BRACKET / 5. SPECIAL BOLT
(1) When installing the steering lock cylinder and steering
lock bracket to the column tube, temporarily install the
steering lock in alignment with the column boss.
(2) After checking that the lock works properly, tighten the
special bolts until the head twists off.
Caution
The steering lock bracket and bolts must be re-
placed with new ones when the steering lock
cylinder is installed.
3. INSTALLATION OF BEARING
Grease: MOPAR Multi-mileage Lubricant
(2) Install the bearings to the shaft on the joint assembly.
(3) Wrap vinyl tape approximately one and one-half times
around the concave circumferences of the bearings,
and then press fit the bearings into the cover assembly.
Part No. 2525035 or equivalent