Mitsubishi Stealth 1994 Import Service Manual page 1223

HEATERS AND MANUAL AIR CONDITIONING
<DOHC>
<SOHC>
SERVICE POINTS OF REMOVAL
1. REMOVAL OF COMPRESSOR DRIVE BELT
(2) Loosen bolt "B" for adjustment, and remove the
compressor drive belt.
3. REMOVAL OF HIGH-PRESSURE HOSE AND LOW-
PRESSURE HOSE A
If the hoses are disconnected, cap the hoses with a blank
plug to prevent entry of dust, dirt, and water.
5. REMOVAL OF COMPRESSOR
Caution
Lay the towel on the brake tube to protect them. When
installing the compressor, do not damage the brake
tubes. This work must be done carefully so as not to
spill the compressor oil.
INSPECTION
Checking for heat damage of the tension pulley.
l
Check for excessive play or deflection of the tension pulley.
l
Check for unusual wear of the tension pulley.
l
Check for hardening of the air conditioning belt.
l
Check for unusual wear or abrasion of the air conditioning
l
belt.
OPERATION CHECK OF THE COMPRESSOR'S MAGNETIC
CLUTCH
terminal of the battery to the compressor.
(2) The condition of the compressor's magnetic clutch can be
considered satisfactory if the operation sound (a "click"
sound) of the magnetic clutch can be heard when this
check is made.
SERVICE POINTS OF INSTALLATION
5. INSTALLATION OF COMPRESSOR
If a new compressor is installed, first adjust the amount of
oil according to the procedures described below, and then
install the compressor.
removed compressor.
(2) Wipe away (from the new compressor) the amount of
oil calculated according to the following formula, and
then install the new compressor.
New compressor oil amount 160 cm3 - X cm3 = Y cm3
( 5 . 4
NOTE
(1) Y cm3 (Y fl.oz.) indicates the amount of oil in the
refrigerant line, the condenser, the cooling unit, etc.
24-3 1